DIY Magnetic Motor (Magnet Generator)

Probably you always wanted to find out what toolsPMG for 10 was well as high speeds. These
and materials will be needed to build a magneticconnections can be changed is two different ways.
motor or magnet generator? Here it is - the list at itsList of tools and materials
best!Fiber glass mat (1 ounce/ square foot) - 300 grams
The PMG functions well at low rotational speed. ItColoring pigment resin - 50 grams
works towards generating 180 watts at 420 rpm.Putty or plasticize Stainless steel wire - 200 grams
This is equivalent to 15 amps at 12 volts.Grade 3 ferrite magnet blocks (pre magnetized) -
The PMG can easily generate more power at higher4000 grams
speed. However, high currents can be a cause ofEnameled winding wire - 3000 grams
heated coils which decreases the efficiency of theFlexible wire Solder & s leaving for connections
Permanent Magnetic Motor. It would be great toY2 inch masking tape Bridge rectifiers
change the stator coils for higher speed. These canHeat sink for rectifiers - 250 grams
be changed via utilizing different size wire or alteringBox section tube (RHS) for spire - 1100 grams
the way in which they are connected.Magnet disk or octagonal plates - 6000 grams
Usage of thicker wire is better for using PMG at10 mm threaded rod (studding) - 500 grams
higher speeds. Thicker wire is capable of carrying10 mm nuts - 300 grams
more current without getting excessively heater up.10 mm washers 8 mm threaded rod - 125 grams
The wire also results in fewer turns on the coils8 mm nuts - 50 grams
which indicate that the PMG will not function at low5 mm nuts & both for rectifiers Shaft - 500 grams
speed.That is it: not difficult to find these item in ant store
Changing the connections will let you utilize the sameto build your magnetic motor - generator.